Monitoring FICON emulation
The -emul argument can be used to monitor FICON Emulation. The following is an example.
Sprint108:root> portshow ficon ge1 0 -emul
XRC and Tape statistics are presented different output formats.
The following elements are common to both tape emulation and XRC emulation outputs:
FDCB ptr
Path
State
442 Configuring and monitoring FICON Extension Services
A pointer to the FICON Device Control Block. Support personnel may use this pointer.
The device path, in the format VE-HD-HP-DD-DP-LP-CU-DV. where:
•
VE is the internal VE_Port number.
•
HD is the hex value for the Host Domain (the entry domain for this host port into
the fabric).
•
HP is the hex value for the Host Port (the entry port of this host connection into the
fabric).
•
DD is the hex value for the Device Domain (the entry domain for this device into the
fabric).
•
DP is the hex value for the Device Port (the entry port for this device connection
into the fabric).
•
LP is the Logical Partition (LPAR) value for the host accessing the specific device.
•
CU is the Control Unit number (CUADDR) for the specific FICON connection.
•
DV is the Device Number of this FICON connected device.
For example, the value 2463016406050001 breaks down as follows.
VE
HD
24
63
A value of zero indicates emulation is idle. Any non-zero value indicates emulation is
active.
HP
DD
DP
01
64
06
05
LP
CU
DV
00
01