Displaying Mode Register Bit Settings; Ficon Cup Mode Register Bits - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Hp storageworks fabric os 6.1.x administrator guide (5697-0234, november 2009)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

Displaying mode register bit settings

The mode register bits are described in
Table 94

FICON CUP mode register bits

POSC
UAM
ASM
DCAM
ACP
HCP
The ficoncupshow modereg command displays the mode register bit settings for the switch. A display
of 0 indicates that the mode register bit is set to off; 1 indicates that the bit is set to on.
The command format is:
ficoncupshow modereg [bitname]
where bitname is one of the mode register bits described in
To display all mode register bit settings for the switch:
switch:admin> ficoncupshow modereg
POSC
UAM
ASM
------------------------------
1
0
To display the mode register bit HCP for the switch:
switch:admin> ficoncupshow modereg HCP
HCP
0
Table
Programmed offline state control. When this bit is set on, the host is prevented from taking
the switch offline. The default setting is 1 (on).
User alert mode. When this bit is set on, a warning is issued when an action is attempted
that will write CUP parameters on the switch. The default setting is 0 (off).
Active=saved mode. When this bit is set on, all CUP configuration parameters are
persistent, meaning that they will be saved in nonvolatile storage in the initial program
load (IPL) file that is applied upon a cold reboot or a power cycle. The default setting is 1
(on).
Switch clock alert mode. When this bit is set on, a warning is issued when the date,
tsClockServer, or tsTimeZone commands are entered to set the time and date on
the switch. The default setting is 0 (off).
Alternate control prohibited. Because the Fabric OS CLI, Web Tools, and Fabric Manager
are considered to be switch consoles, this bit has no effect on their operation. Attempts to
set CUP parameters through SNMP are denied when this bit is set on. The default setting
is 1 (on).
Host control prohibited. When this bit is set on, the host is not allowed to set CUP
parameters. The default setting is 0 (off).
DCAM
ACP
HCP
1
0
1
0
94.
Table
94.
Fabric OS 6.1.x administrator guide 425

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents