FC4- 1 6IP Blade Configuration
This section describes the initial setup required to deploy an iSCSI gateway solution.
NOTE:
Only the 4/256 SAN Director with an iSCSI-enabled FC4- 1 6IP blade running Fabric OS 5.2.0 or
later supports the iSCSI gateway service.
You can also configure an FC4- 1 6IP blade through the Web Tools Graphical User Interface as an
alternative to the command line interface. Refer to the Web Tools Administrator's Guide for descriptions of
GUI-based configuration procedures.
FC4- 1 6IP port numbering
The FC4- 1 6IP blade integrates both GbE ports and FC ports. Ports are addressed using slot number and
port number notation, for example, 2/7. FC ports are numbered from 0 through 7; GbE ports are
numbered from ge0 through ge7.
NOTE:
The FC4- 1 6IP blade does not support FCIP functionality.
5/ 16" = 1"
A
Rev
56-0000590-01
!
ge7
ge7
ge6
ge5
ge4
G E
ge3
ge2
ge1
ge0
ge0
7
7
6
5
4
F C
3
2
1
0
0
F C 4
16IP
Figure 22
FC4- 1 6IP ports
s c al e:
G bE ports
F C ports
40. 1
Fabric OS 6.1.x administrator guide 257