HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 359

NOTE: In the following procedure the three TI zones in the edge and backbone fabrics are all given the
same name, TI_Zone1. It is not required that the TI zones have the same name; this is done to avoid
confusion. If several dedicated paths are set up across the FC router, the TI zones for each path can have
the same name.
1. In each edge fabric, set up an LSAN zone that includes Host 1, Target 1, and Target 2, so these devices
can communicate with each other. See Chapter 17,
information about creating LSAN zones.
2. Log in to edge fabric 1 and set up the TI zone.
a. Enter the fabricShow command to display the switches in the fabric. From the output, you can
determine the front and translate domains.
E1switch:admin> fabricshow
Switch ID Worldwide Name
-------------------------------------------------------------------------
1: fffc01 50:00:51:e3:95:36:7e:04
4: fffc04 10:00:00:60:69:80:1d:bc
6: fffc06 50:00:51:e3:95:48:9f:a0
The Fabric has 3 switches
b. Enter the following commands to create and display a TI zone:
E1switch:admin> zone --create -t ti TI_Zone1 -p "4,8; 4,5, 1,-1; 6,-1"
E1switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name:
Port List:
Status: Activated
c. Enter the following commands to reactivate your current effective configuration and enforce the TI
zones.
E1switch:admin> cfgactvshow
Effective configuration:
cfg: cfg_TI
zone: lsan_t_i_TI_Zone1
E1switch:admin> cfgenable cfg_TI
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
If the update includes changes to one or more traffic isolation zones, the
update may result in localized disruption to traffic on ports associated
with the traffic isolation zone changes
Do you want to enable 'cfg_TI' configuration
zone config "cfg_TI" is in effect
Updating flash ...
Enet IP Addr
0.0.0.0
10.32.72.4
0.0.0.0
TI_Zone1
4,8; 4,5; 1,-1; 6,-1
Failover: Enabled
10:00:00:00:00:00:02:00:00
10:00:00:00:00:00:03:00:00
10:00:00:00:00:00:08:00:00
"Using the FC-FC routing
FC IP Addr
0.0.0.0
0.0.0.0
0.0.0.0
(yes, y, no, n): [no] y
Fabric OS 6.2 administrator guide 357
service" on page 367 for
Name
"fcr_fd_1"
>"E1switch"
"fcr_xd_6_9"