HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 171

5. Respond to the prompts as follows:
Protocol (scp or
ftp)
Server Name or IP
Address
User name
File name
Section
Password
6. At the Do you want to continue [y/n] prompt, enter y.
7. Wait for the configuration to be restored.
The following example shows configDownload run on a switch without Admin Domains:
switch:admin> configdownload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 10.1.2.3
User Name [user]: joeUser
File Name [config.txt]:
Section (all|chassis|FID# [all]): all
This command is used to download a backed-up configuration
for a specific switch.
switch, this file's configuration
any current switch settings.
file, which was uploaded
may cause this switch to fail.
required for some parameter changes to take effect.
configDownload operation may take several minutes
to complete for large files.
Do you want to continue [y/n]: y
Password: <hidden>
configDownload complete.
If your site requires the use of Secure Copy, specify scp. Otherwise, specify ftp.
Enter the name or IP address of the server where the file is stored; for example,
192.1.2.3. You can enter a server name if DNS is enabled.
Enter the user name of your account on the server; for example, JohnDoe.
Specify the full path name of the backup file; for example,
/pub/configurations/config.txt
Specify -all for the chassis, switch, or Logical Switches, or specify -chassis for
the chassis only, -fid to download a switch configuration data to a Logical Switch
specified by its fabric ID. This parameter is valid only in a Virtual Fabric environment
and requires chassis permissions.
Enter your account password for the server. Note that this is a required field even if
you are logged in as an anonymous user; in such cases, the value may be ignored
by the FTP service.
*** CAUTION ***
If using a file
Downloading a configuration
from a different type of switch,
A switch reboot might be
from a different
settings will override
Fabric OS 6.2 administrator guide 169