Adding A Member To The Acl - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

In the following example, the list is empty:
switch:admin> msconfigure
0
1
2
3
select : (0..3) [1] 1
MS Access list is empty.
0
1
2
3
select : (0..3) [1] 0
done ...
switch:admin>

Adding a member to the ACL

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the select prompt, enter 2 to add a member based on its port/node WWN.
4. At the Port/Node WWN prompt, enter the WWN of the host to be added to the ACL.
5. At the select prompt, enter 1 to display the access list so you can verify that the WWN you entered
was added to the ACL.
6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7. At the Update the FLASH? prompt, enter y.
Done
Display the access list
Add member based on its Port/Node WWN
Delete member based on its Port/Node WWN
Done
Display the access list
Add member based on its Port/Node WWN
Delete member based on its Port/Node WWN
Fabric OS 6.2 administrator guide 295