Switch Section; Configuration File Backup; Uploading A Configuration File In Interactive Mode - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Switch section

There is always at least one switch section for the default switch or a switch that has Virtual Fabric mode
disabled. There are additional sections corresponding to each additionally defined Logical Switch instance
on a switch with Virtual Fabrics mode enabled. These are the switch-specific data that affect only that
Logical Switch's behavior. The following components are in the switch section of the configuration file:
• boot parameters
• configuration
• zoning
• defined security policies
• active security policies
• iSCSI
• cryptoDev
• FICU saved files

Configuration file backup

In case the configuration is lost or unintentional changes are made, keep a backup copy of the
configuration file. You should keep individual backup files for all switches in the fabric and avoid copying
configurations from one switch to another. The configUpload command, by default, uploads only the
switch context configuration for the Logical Switch context in which the command is executed.
In non-Virtual Fabric mode, you must use the configUpload
and the chassis information. In Virtual Fabric mode, the configUpload
to upload all Logical Switches and the chassis configuration. Only administrators with the chassis role
permission are allowed to upload other FIDs or the chassis configuration.
The following information is not saved in a backup:
• dnsConfig information
• passwords
If your FTP setup supports anonymous users, and you log in as an anonymous user, password is still a
required field, even though its value may be ignored by the FTP service.
Before beginning, verify that you can reach the FTP server from the switch. Using a Telnet connection, save
a backup copy of the configuration file from a Logical Switch to a host computer.
If you have the chassis role permissions added to your user account, the following options are available:
-fid
-all (default)
-chassis

Uploading a configuration file in interactive mode

1. Verify that the FTP or SCP service is running on the host computer.
Connect to the switch and log in as admin.
2.
3. Enter the configUpload command.
The command becomes interactive and you are prompted for the required information.
Uploads the specified FID's configuration.
Uploads all of the system's configuration, including the chassis section and all
switch sections for all Logical Switches.
Note: Use this parameter when obtaining a complete capture of the switches'
configuration in a switch that has Virtual Fabric mode disabled.
Uploads only the chassis section of the system's configuration file.
all command to include both the switch
-
all command can be selected
-
Fabric OS 6.2 administrator guide 165