Modifying Domain Ids - HP AA-RSB6B-TE Installation Manual

7. At the prompt type, SwitchEnable.
8. After setting the Core PID to match the the other switches in the fabric, go to
9. If necessary, type cfgEnable to re-establish zoning.
Note:
and it is NOT necessary to set it again during subsequent firmware upgrades.

Modifying Domain IDs

Optional. Modify the domain IDs if desired, as follows.
Note:
switches in the SAN. This eliminates the possibility of domain ID overlap.The default
domain ID is 1. If the default domain ID is already in use when the switch is connected
to the fabric, the domain ID for the new switch is automatically reset to a unique value.
The domain IDs that are currently in use can be determined using the telnet command,
fabricShow.
1. To disable the switch, type:
2. Enter the following:
hp StorageWorks SAN Switch 2/8 Installation Guide
Committing configuration...Done
the "Connecting the SAN Switch 2/8 to the
chapter, for instructions on connecting Fibre Channel cables.
Once the switch PID format is set, it is stored in the flash memory of the switch
It is best to assign a unique domain ID prior to connecting the switch to other
switchDisable
configure
Installing the SAN Switch 2/8
LAN" section on page 50 in this
53