Recognition Systems HANDKEY II Manual page 57

A Remote Reader has single-dashes surrounding the "READY" text.
Set Serial The Set Serial command allows you to select either the RS-485, RS-422 or RS-
232 communication mode and to set the baud rate for the selected
communication mode. The default baud rate is 9600 bps which is suitable for
most network communication applications. If the HandReader uses the Ethernet
communication option, the TCP/IP address, gateway, and host bit parameters
are set instead of the baud rate.
Set Duress The Set Duress Code command allows a special digit code to be defined that,
Code when entered before a user's PIN entry, sends a silent alarm to security
personnel using an auxiliary output. This function only works with keypad ID
number entry systems – it does not work with Card Reader entry systems. If a
Duress Code is set, an ID Length cannot be set by the Set ID Length command.
For this function to work properly the following must be true: an auxiliary output
NOTE
must be defined to activate on DURESS and assigned ID numbers cannot begin
with the duress code number.
Set Beeper The Set Beeper command allows the beeper to be enabled or disabled. When
enabled, the beeper sounds an audible response to key strokes and events.
Upgrade For instructions on how to upgrade the memory of the HandReader please refer
to the Memory Upgrade Note.
= READY
TIME DATE
– READY
TIME DATE
=
–
HandKey CR Manual
Page 55