Recognition Systems HANDKEY II Manual page 53

Table 9: Setup Command Menu
Setup Menu
Password = 2
Output Set on Battery Backup
Auxiliary Output Cleared by Timer
Aux Output Cleared by Valid Access
Set Reader Mode
To Master/Remote
a
Set Serial
RS-422 (Y/N)
Select Baud Rate
RS-232 (Y/N)
Select Baud Rate
Use RS-232 for Printer or Host
a
Set Serial
Verify/Enter IP Address
Verify/Enter Gateway
Verify/Enter Host Bit
Set Duress Code
Enter Duress Code
Set Beeper
Turn Beeper On/Off (Y/N)
Upgrade
Enter Code
a. The Set Serial command has different val-
ues based on whether the HandReader is
configured for serial or modem communi-
cation versus Ethernet communication.
HandKey CR Manual
Page 51