Setup Menu - Recognition Systems HANDKEY II Manual

Setup Menu

The Setup menu commands allow you to set the basic operating parameters for
the HandReader.
Once in the Setup menu you can step through and set the parameters for each
NOTE
command sequentially. You do not have to exit command mode after setting any
individual command.
Navigating the Once you have entered the Setup menu, there are three options available for
Setup Menu navigating the command menu system.
• Press
• Press
• Press
also exits the command menu). If you are in a command's sub-menu, you
may have to press
command menu.
Setup There are 12 commands available from the Setup command menu.
Commands
• Set Language
• Set Date Format
• Set Time and Date
• Set Address
• Set ID Length
• Set Facility
• Aux Out Control
• Set Reader Mode
• Set Serial
• Set Duress Code
• Set Beeper
• Upgrade
Refer to and identify the command you need to perform. Step through all
previous commands until you reach the desired command.
#
to enter the command shown on the display.
*
to step to the next command in the menu.
CLEAR
to exit the command menu (pressing any numeric key
CLEAR
multiple times to completely exit the
HandKey CR Manual
Page 49