Recognition Systems HANDKEY II Manual page 40

Enter a Command Menu
4. Enter the password for the menu you wish to enter. The default passwords
are as follows.
Press
Press
Press
Press
Press
5. Press
6. If you are authorized to use this command the first command option in the
selected menu appears.
7. If you are not authorized to enter this command the display appears as
follows.
To access all five menus you must be the first person enrolled in a new system
NOTE
installation or you must have the highest authority level and the correct
passwords for all five menus. If you are blocked from a menu to which you
should have access, verify your access/password rights with management
personnel. If authority levels or passwords have been incorrectly changed and
you must have access to all menus, it is possible to reset the HandReader's
memory. Resetting memory allows access to all five menus by the first person
enrolled (as if it is a new system installation), but this means that any user
information programmed into the HandReader must be re-entered (manually or
by using HandNet software to restore the user information). Be sure you need to
reset memory before performing this function. To reset memory, refer to the
Erasing HandReader Memory on page 35.
Navigating Once an operator has entered a command menu, there are three options
Command available for navigating the command menu system.
Menus
• Press
• Press
Page 38
1
for the Service Menu.
2
for the Setup Menu.
3
for the Management Menu.
4
for the Enrollment Menu.
5
for the Security Menu.
ENTER
.
READY
*:
#
to enter the command shown on the display.
*
to step to the next command in the menu.