Remote Handreader Connected To A Host Pc Via Optional Ethernet; Printer - Recognition Systems HANDKEY II Manual

Remote The HandReader is available with an optional, internal Ethernet communications
HandReader module for TCP/IP communications. The wiring must conform to 10BaseT
Connected to standards. Typically, network wiring terminates at the HandReader with a
a Host PC via standard RJ-45 modular jack. The cable from the jack to the HandReader is not
Optional provided with the Ethernet option. The IP address, Gateway, and Host Bits are
Ethernet entered at the HandReader in the SET SERIAL menu. Ethernet HandReaders may
be networked with up to 31 non-Ethernet HandReaders using RS-422 twisted
pair cable. Refer to the Ethernet Application Note (available from Recognition
Systems) for detailed information.

Printer

You can connect a serial printer to a HandReader. A printer connected to the
master HandReader (in a master-remote application) will print every event as it
occurs. A printer connected to a remote HandReader will print only the events
that occur at that HandReader. Recognition Systems Inc. does not supply serial
printers. Refer to the Printer String Application Note (available from Recognition
Systems) for detailed information.
HandKey II Manual
Page 19