Installing An Additional Microprocessor - IBM xSeries 225 8647 Installation Manual

10. Replace the support bracket (see "Removing and installing the support
11. Replace the side cover (see "Replacing the bezel" on page 39).
12. Reconnect the external cables and power cords. Turn on the attached devices,

Installing an additional microprocessor

Your server comes with one microprocessor installed on the system board. Your
server supports up to two microprocessors. With two microprocessors, your server
can operate as a symmetric multiprocessing (SMP) server. With SMP, certain
operating systems and application programs can distribute the processing load
among the microprocessors.
5. Open the retaining clips and, if necessary, remove any existing DIMM.
6. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then remove the new DIMM from the package.
7. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM
so that the pins align correctly with the connector.
8. Insert the DIMM into the connector. Firmly press the DIMM straight down into
the connector by applying pressure on both ends of the DIMM simultaneously.
The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector. If there is a gap between the DIMM and the retaining
clips, the DIMM has not been correctly installed. Open the retaining clips,
remove the DIMM, and then reinsert it.
9. If you have other options to install or remove, do so now.
bracket" on page 12).
and turn on the server.
DIMM 1
DIMM 2
DIMM 3
DIMM 4
Chapter 2. Installing options
29