Installing An Additional Microprocessor - IBM System x3850 Installation Manual

Hide thumbs Also See for System x3850:

Table of Contents

Installing an additional microprocessor

The following notes describe information that you must consider when installing a

microprocessor:

v The voltage regulators for microprocessors 1 and 2 are integrated on the

v Each microprocessor socket must be populated with either a microprocessor

v Install the microprocessors in the order shown in the following illustration.

Complete the following steps to install an additional microprocessor:

IBM System x3850 Type 8864: Installation Guide

microprocessor board; the VRMs for microprocessors 3 and 4 come with the

microprocessor options and must be installed on the microprocessor board.

baffle or a heat sink and microprocessor to ensure the server operates properly.

1. Read the safety information beginning on page v and "Installation guidelines"

on page 7.

2. Turn off the server and peripheral devices, and disconnect the power cords

and any USB cable that might be connected to the USB port on the front of

the server. Remove the server cover and bezel.

Attention:

When you handle static-sensitive devices, take precautions to

avoid damage from static electricity. For details about handling these devices,

see "Handling static-sensitive devices" on page 9.

Table of Contents

8864