Removing A Pci Add-In Card; Figure 43. Removing A Full Height Add-In Card - Intel SR1500AL - Server System - 0 MB RAM User Manual

10. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser
11. Install the processor air duct. For instructions, see
Duct".
12. Install the server system cover. For instructions, see
13. Plug all peripheral devices and the AC power cable(s) into the server.

Removing a PCI Add-in Card

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter "A").
7. Remove the PCI add-in card from the riser card connector (see letter "B").
8. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser
®
Intel Server System SR1500AL User's Guide
Assembly".

Figure 43. Removing a Full Height Add-In Card

Assembly".
"Installing the Processor Air
"Installing the System
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
A
B
AF000362
Cover".
"Safety
53