Installing And Removing A Pci Add-In Card; Installing A Pci Add-In Card; Figure 42. I Installing A Full Height Add-In Card - Intel SR1500AL - Server System - 0 MB RAM User Manual

16. Install the server system cover. For instructions, see
17. Plug all peripheral devices and the AC power cable(s) into the server.

Installing and Removing a PCI Add-in Card

The instructions below describe how to install and remove a PCI add-in card.

Installing a PCI Add-in Card

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter "A").
7. Remove the filler panel from the selected add-in card slot (see letter "B").
8. Insert add-in card until it seats in riser card connector (see letter "C").
9. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
52

Figure 42. I Installing a Full Height Add-In Card

"Installing the System
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
A
B
C
®
Intel Server System SR1500AL User's Guide
Cover".
"Safety
AF000361