Removing The Intel ® Rmm And Intel ® Rmm Nic - Intel SR1500AL - Server System - 0 MB RAM User Manual

9. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser
10. Install the processor air duct. For instructions, see
Duct".
11. Install the server system cover. For instructions, see
12. Plug all peripheral devices and the AC power cable(s) into the server.
Removing the Intel
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the PCI riser assembly. For instructions, see
Assembly".
5. Remove the Intel
below).
6. Remove the Intel
figure below).
7. Remove the standoffs from the server board (see letter "C" in the figure below).
8. Install the ntel
in the figure below).
Figure 47. Removing the Intel
9. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser
10. Install the processor air duct. For instructions, see
Duct".
®
Intel Server System SR1500AL User's Guide
Assembly".
®
RMM and Intel
®
RMM board from the server board (see letter "A" in the figure
®
RMM NIC module from the server board (see letter "B" in the
®
RMM NIC module cover into the system back panel (see letter "D"
A
®
RMM and the Intel
the Server System
Assembly".
"Installing the Processor Air
"Installing the System
®
RMM NIC
"Removing the System
"Removing the PCI Riser
B
C
®
RMM NIC Module from
"Installing the Processor Air
Cover".
"Safety
D
AF000900
57