Removing The Blade Server Bezel Assembly; Installing A Sas Hard Disk Drive - Intel SBXD62 - Server Compute Blade Installation And User Manual

Removing the Blade Server Bezel Assembly

To install certain options, you must first remove the blade server bezel assembly. The
following illustration shows how to remove the bezel assembly.
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on
Information"
2. Open the blade server cover (see
instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the blade
server approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.

Installing a SAS Hard Disk Drive

The blade server has two connectors on the system board for installing optional SFF SAS
hard disk drives.
Each SAS connector is on the same bus. Depending on the blade server model, at least one
SAS hard disk drive might already be installed. If the blade server is equipped with one
SAS hard disk drive, you can install an additional SAS hard disk drive. These two SAS
hard disk drives can be used to implement and manage a redundant array of independent
disks (RAID) level-1. See
about SCSI RAID configuration.
Intel® Server Compute Blade SBXD62 Installation and User's Guide
Bezel-assembly
release
Control panel
connector
and "Installation Guidelines" on page
"Opening the Blade Server Cover" on page 18
"Configuring a SCSI RAID Array" on page 42
Bezel-assembly
release
Control-panel AF000438
cable
page 65 in Appendix C, "Safety
15.
for
for information
19