Removing The Blade Server Bezel Assembly - Intel SBXD132 - Server Compute Blade Installation And User Manual

b. Use the extraction device on the expansion unit, if one is present, to disengage the
expansion unit from the system board. These extraction devices can be of several
types, including thumb screws or levers.
c. Rotate the expansion unit open, as shown in the illustration; then, lift the
expansion unit from the blade server.

Removing the Blade Server Bezel Assembly

To install certain options, you must first remove the blade server bezel assembly. The
following illustration shows how to remove the bezel assembly.
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page
page
2. Open the blade server cover (see
instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the blade
server approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Intel® Server Compute Blade SBXD132 Installation and User's Guide
Bezel-assembly
release (both sides)
15.
Control-Panel
Cable
Control-panel
connector
AF000933
vii and "Installation Guidelines" on
"Opening the Blade Server Cover" on page 17
Bezel
for
19