Removing The Blade Server Bezel Assembly - Intel SBX44 - Server Compute Blade Installation And User Manual

2. Carefully lay the blade server down on a flat, non-conductive surface, with the cover side up.
3. Press the green blade-cover release (A) on each side of the blade server and lift the cover open,
as shown in the illustration.
4. Lay the cover flat, or lift it from the blade server.
xxCAUTION:
Hazardous energy is present when the blade is connected to the power source. Always replace
the blade cover before installing the blade.

Removing the blade server bezel assembly

To install certain options, you must first remove the blade server bezel assembly. The following
illustration shows how to remove the bezel assembly from a blade server.
Complete the following steps to remove the blade server bezel assembly:
1. Review the information in "General Safety" and "Electrical Safety" beginning on page vi and
"Installation guidelines" on page 19.
2. Open the blade server cover.
3. Press the green bezel-assembly release (A) and tilt the bezel assembly away from the blade
server chassis.
Installing options
A
TP00436
21