Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 117

baseline path interface sonet
baseline section interface sonet
Copyright © 2010, Juniper Networks, Inc.
Use the total [ delta ] keywords with the show controllers sonet line command to
view the baseline statistics.
Example 1—Sets a baseline for SONET line layer interfaces on ERX14xx models, ERX7xx
models, or the ERX310 router
host1#baseline line interface sonet 2/0
Example 2—Sets a baseline for SONET line layer interfaces on the E320 Broadband
Services Router
host1#baseline line interface sonet 3/0/0
There is no no version.
See baseline line interface sonet.
Use to set a statistics baseline for the SONET/SDH path layer.
The router implements the baseline by reading and storing the MIB statistics at the
time the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the total [ delta ] keywords with the show controllers sonet path command to
view the baseline statistics.
Example 1—Sets a baseline for SONET path layer interfaces on ERX14xx models, ERX7xx
models, or the ERX310 router
host1#baseline path interface sonet 2/0
Example 2—Sets a baseline for SONET path layer interfaces on the E320 router
host1#baseline path interface sonet 3/0/0
There is no no version.
See baseline path interface sonet.
Use to set a statistics baseline for the SONET/SDH section layer.
The router implements the baseline by reading and storing the MIB statistics at the
time the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the total [ delta ] keywords with the show controllers sonet section commands
to view the baseline statistics.
Example 1—Sets a baseline for SONET section layer interfaces on ERX14xx models,
ERX7xx models, or the ERX310 router
host1#baseline section interface sonet 2/0
Example 2—Sets a baseline for SONET section layer interfaces on the E320 router
host1#baseline section interface sonet 3/0/0
Chapter 3: Configuring Unchannelized OCx/STMx Interfaces
95