Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 62

JunosE 11.3.x Physical Layer Configuration Guide
show controllers t3 serial
40
Bursty errored seconds—Number of bursty errored seconds encountered by a T1 in
the current interval
Degraded minutes—Number of minutes that a T1 line is degraded
Example—In this example, a T1 channel is specified.
host1#show controllers t1 10/1:1 remote
DS1 10/1:1
Number of valid interval - 0
Time elapse in current interval - 0
Far End FDL Carrier bit is not set
Far End Equipment Identification Code is the null string
Far End Line Identification Code is the null string
Far End Frame Identification Code is the null string
Far End Unit Identification Code is the null string
Far End Facility Identification Code is the null string
Far End Port Number is the null string
Far End Generator Number is the null string
DS1 Current Interval Counters
Errored seconds
Severely errored second
Severely errored frame seconds = 0
Unavailable seconds
Clock slip seconds
Path code violations
Line errored seconds
Bursty errored seconds
Degraded minutes
DS1 24 Hour Total Counters
Errored seconds
Severely errored second
Severely errored frame seconds = 0
Unavailable seconds
Clock slip seconds
Path code violations
Line errored seconds
Bursty errored seconds
Degraded minutes
See show controllers t3 remote.
Use to display the state of the serial interface.
Field descriptions
Description—Text description or alias if configured for the interface
ifOperStatus—Physical status of the interface
ifOperUp—Interface is functioning
ifOperTesting—Interface is being tested
ifOperNotPresent—Module has been removed from the chassis
ifOperDown—Interface is not functioning
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
Copyright © 2010, Juniper Networks, Inc.