Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 55

Copyright © 2010, Juniper Networks, Inc.
5/6(channelized)
5/7(channelized)
5/8(channelized)
5/9(channelized)
5/10(channelized)
5/11(channelized)
3/0(channelized)
3/1(channelized)
3/2(channelized)
4/0:1/1(unchannelized)
4/2:1/1(channelized)
Field descriptions for a T1 channel
Description—Text description or alias if configured for the interface
ifOperStatus—Physical state of the interface:
ifOperDown—Interface is not functioning
ifOperLowerLayerDown—Lower layer in the interface stack is not functioning
ifOperNotPresent—Module has been removed from the chassis
ifOperTesting—Interface is being tested
ifOperUp—Interface is functioning
Yellow Alarm detection—Status of yellow alarm detection: active or not active
Yellow Alarm generation—Status of yellow alarm generation: active or not active
snmp trap link-status—Status of SNMP trapping (enabled or disabled)
Framing—Type of framing format
Clock source—Type of clock source
Loopback state—Type of loopback (if enabled) and status: enabled or disabled
Last remote loopback request sent—None or deactivate
FDL—Status of FDL: standard configured or not configured
FDL Transmit Path—Status of path transmission: active or not active
FDL Transmit Idle-Signal—Status of idle signal: active or not active
FDL Transmit Test-Signal—Status of test signal: active or not active
Equipment Identification Code—eic string for FDL
Line Identification Code—lic string for FDL
Frame Identification Code—fic string for FDL
Unit Identification Code—unit string for FDL
Facility Identification Code—pfi string for FDL
Chapter 1: Configuring Channelized T3 Interfaces
down down
down down
down down
down down
down down
down down
down down
down down
down down
up down
up lowerLayerDown
33