Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 56

JunosE 11.3.x Physical Layer Configuration Guide
34
Port Code—port string for FDL
Generator Number—generator string for FDL
BERT test—Number of current test and total number of tests
Test interval—Length of the BERT test
status—Sync (controller is synchronized with remote device) or NoSync (controller
is not synchronized with remote device)
Sync count—Number of times the pattern detector synchronized with the incoming
data pattern
Received bit count—Number of bits received
Error bit count—Number of bits with errors
Number of valid intervals—Number of 15-minute intervals since the line module was
last powered on or reset
Time elapse in current interval—Statistics are reported in 15-minute intervals
Errored seconds—Number of errored seconds encountered by a T1 in the current
interval
Severely errored seconds—Number of severely errored seconds encountered by a
T1 in the current interval
Severely errored frame seconds—Number of severely errored framing seconds
encountered by a T1 in the current interval
Unavailable seconds—Number of unavailable seconds encountered by a T1 in the
current interval
Clock slip seconds—Number of clock slips encountered by a T1 in the current interval
Path code violations—Number of coding violations encountered by a T1 in the current
interval
Line errored seconds—Number of line errored seconds encountered by a T1 in the
current interval
Bursty errored seconds—Number of bursty errored seconds encountered by a T1 in
the current interval
Degraded minutes—Number of minutes that a T1 line is degraded
Line code violations—Number of line code violations encountered by a T1 in the
current interval
Example 1—In this example, a T1 channel and the brief keyword are specified.
host1#show controllers t1 2/0:1 brief
DS3 2/0:1
Copyright © 2010, Juniper Networks, Inc.