Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 52

JunosE 11.3.x Physical Layer Configuration Guide
30
Xmt RAI Failure—Local device is sending a far end alarm failure
Rcv AIS—Remote device is sending an alarm indication signal (AIS)
Xmt AIS—Local device is sending an AIS
Rcv LOF—Loss of one or more frames from the remote end
Rcv LOS—Loss of signal at the local end
Undefined line status—Indicates that the line is in an undefined state
NOTE: The alarms detected field does not appear for interfaces that
you disabled in the software.
framing—Type of framing format
line code—Type of line code format
clock source—Type of clock source
cable length—Cable length, in feet
Loopback—State of loopback for the controller: enabled or disabled. If loopback is
enabled, one of the following states is displayed:
Diagnostic—Loops the data back toward the router and sends an AIS toward the
network
Payload—Loops the data toward the network after the framer has processed the
data
Line—Loops the data toward the network before the data reaches the framer
MDL Transmit Path—Status of path transmission: active or not active
MDL Transmit Test-Signal—Status of test signal: active or not active
MDL Transmit Idle-Signal—Status of idle signal: active or not active
Equipment Identification Code—eic string for MDL
Line Identification Code—lic string for MDL
Frame Identification Code—fic string for MDL
Unit Identification Code—unit string for MDL
Facility Identification Code—pfi string for MDL
Port Code—port string for MDL
Generator Number—generator string for MDL
Copyright © 2010, Juniper Networks, Inc.