Provisioning The Maximum Number Of Interfaces On A Tunnel-Server; Port; Reserving Bandwidth On Shared Tunnel-Server Ports - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual

Software for e series broadband services routers physical layer configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Physical Layer Configuration Guide
host1#show tunnel-server config

Port

Type
MaximumInterfaces
--------
-------
-----------------
Port 2/2/0
shared
Port 8/0/0
dedicated
Port 12/0/0
shared
Provisioning the Maximum Number of Interfaces on a Tunnel-Server Port

Reserving Bandwidth on Shared Tunnel-Server Ports

218
Server Ports
------------
Provisioned
Interfaces
-----------
8000
0
16000
8000
8000
0
To provision the maximum number of interfaces on a tunnel-server port:
From Global Configuration mode, specify the location of the dedicated tunnel-server
1.
port that you want to configure.
On a dedicated tunnel-server port:
host1(config)#tunnel-server 8/0/0
host1(config-tunnel-server)#
On a shared tunnel-server port:
host1(config)#tunnel-server 2/2/0
host1(config-tunnel-server)#
This command accesses Tunnel Server Configuration mode.
NOTE: When you issue the tunnel-server command, ensure that you
specify the same interface specifier that was displayed for this
tunnel-server port in the show tunnel-server config command in the
output described in "Identifying the Physical Location of the Tunnel-Server
Port" on page 217. If you specify an incorrect location for the tunnel-server
port, the router displays an error message and rejects the command as
invalid.
Provision the maximum number of tunnel-service interfaces to be used on the
2.
dedicated tunnel-server port.
host1(config-tunnel-server)#max-interfaces all-available
NOTE: When you enable shared tunnel server on the ES2 10G ADV LM, it
reloads with a warning message and then the image specific to shared tunnel
server appears.
To reserve a certain percentage of the total bandwidth for forwarding on a shared
tunnel-server port:
HwPresent
Bandwidth-Reserved
---------
-----------------
yes
N/A
yes
N/A
yes
90
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents