Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 118

JunosE 11.3.x Physical Layer Configuration Guide
show controllers sonet
96
There is no no version.
See baseline section interface sonet.
Use to display the configuration for SONET and SDH interfaces.
Field descriptions
Interface specifier in slot/port format (ERX14xx models, ERX7xx models, and the
ERX310 router) or slot/adapter/port format (E120 and E320 routers)
non channelized—Unchannelized path
channelized—Number of channels and speed for the interface
ifAdminStatus—Configured status of the interface: up or down
description—Configured description of the controller
snmp trap link-status—State of SNMP link-status processing for the section and
line layers of the interface: enabled or disabled
alarms used for operational status calculation—Types of defects that the router
uses to determine the operational status of the interface at the section and line
layers
defect trigger soaking delay—Time that the router waits to set an alarm when the
router records a defect at the section or line layer
Operational Status—Physical state of the interface:
up—Interface is operational
down, failure alarm—Interface is not operational; type of defect that caused failure
is specified
time since last status change—Time the controller has been in the current physical
state
Loopback State—Type of loopback configured on the interface
Mode—Type of interface: SONET or SDH
Timing source—Type of clock source configured for the channel:
line—Internal clock is from the line module itself
chassis—Internal clock is from the configured router clock
Receive FIFO Overruns—Number of times received FIFO was overrun
Current section defects—Number of suspect bit patterns found in several consecutive
frames in section layer
Copyright © 2010, Juniper Networks, Inc.