Configuring An Unframed E1 Line - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual

JunosE 11.3.x Physical Layer Configuration Guide
path ds1|e1
path ds1|e1 description
path e1 unframed
120
(Optional) Assign a text description or an alias to the interface.
2.
Configure one of the following:
3.
An unframed E1 line. (See "Configuring T1 and E1 Lines" on page 121.)
A T1 or an E1 line. (See "Configuring T1 and E1 Lines" on page 121.)
For detailed examples, see "Configuration Examples" on page 136.
Use to create and configure SONET tributaries, SDH tributaries, and T1 or E1 on the
path.
Example
host1(config-controller)#path 2 ds1 1/7/4 vt15
Use the no version to delete SONET and SDH tributaries.
See path ds1|e1.
Use to assign a text description or an alias to a T1/E1 over SONET/SDH VT layer on
channelized SONET and SDH interfaces.
You can use this command to help you identify the interface and keep track of interface
connections.
The description or alias can be a maximum of 80 characters.
Use "show controllers sonet ds1|e1" on page 153 to display the text description.
Example
host1(config-controller)#path 2 ds1 1/7/4 description nyc01
Use the no version to remove the text description or alias.
See path ds1|e1 description.

Configuring an Unframed E1 Line

Use the following command to configure an unframed E1 line.
Use to configure an unframed E1 on the path.
You cannot configure a mixture of T1 and E1 lines on the same cOCx/STMx line module.
When you issue this command, the router creates one channel for the unframed E1
line, and assigns the number one to that channel.
Example
host1(config-controller)#path 1 e1 1/7/4
host1(config-controller)#path 1 e1 1/7/4 unframed
Copyright © 2010, Juniper Networks, Inc.