Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 60

Software for e series broadband services routers physical layer configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Physical Layer Configuration Guide
38
Far End Unit Identification Code—unit string sent by remote device for MDL
Far End Facility Identification Code—pfi string sent by remote device for MDL
Far End Generator Number—generator string sent by remote device for MDL
Far End Port Number—port string sent by remote device for MDL
Number of valid intervals—Number of 15-minute intervals since the line module was
last powered on or reset
Time elapse in current interval—Number of seconds that have passed in the 15-minute
(900-second) interval
C-bit errored seconds—Number of C-bit errored seconds encountered by a T3 in the
current interval
C-bit severely errored seconds—Number of C-bit severely errored seconds
encountered by a T3 in the current interval
C-bit coding violations—Number of C-bit coding violations encountered by a T3 in
the current interval
Unavailable seconds—Number of unavailable seconds encountered by a T3 in the
current interval
Invalid seconds—Number of seconds when statistics were not collected
Example—In this example, a T3 interface is specified.
host1#show controllers t3 5/0 remote
Far End MDL Carrier bit is not set
Far End Equipment Identification Code is the null string
Far End Line Identification Code is the null string
Far End Frame Identification Code is the null string
Far End Unit Identification Code is the null string
Far End Facility Identification Code is the null string
Far End Generator Number is the null string
Far End Port Number is the null string
Number of valid interval - 3
Time elapse in current interval - 756
Ds3 Current Interval Counters
C-bit errored seconds
C-bit severely errored seconds = 0
C-bit coding violations
Unavailable seconds
Invalid seconds
Ds3 Last Interval Counters
C-bit errored seconds
C-bit severely errored seconds = 0
C-bit coding violations
Unavailable seconds
Invalid seconds
Ds3 24 Hour Total Counters
C-bit errored seconds
C-bit severely errored seconds = 1
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 1
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents