Interface Stack; Numbering Scheme; Figure 3: Stack For T3 Atm Interfaces; Figure 4: Stack For T3 Frame And E3 Frame Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual

Interface Stack

Numbering Scheme

Copyright © 2010, Juniper Networks, Inc.
T3 (DS3) ports per I/O module. Each port uses two SMB connectors: one for the transmit
(TX) connection and one for the receive (RX) connection.
CT3/T3-F0 line modules and CT3/T3 12 I/O I/O modules to support the following:
Clocking
Redundancy
Frame Relay logical interface support
Unique IP interface support for each PPP or Frame Relay PVC interface
Line speeds of 45 Mbps
Figure 3 on page 49 shows the stack for T3 ATM interfaces. Figure 4 on page 49 shows
the stack for T3 frame and E3 frame interfaces.
To configure a T3 ATM interface, first configure a T3 controller. To configure ATM
parameters, see Configuring ATM in JunosE Link Layer Configuration Guide .
To configure a T3 frame or E3 frame interface, first configure a T3 or E3 controller, and
then configure a High-Speed Data Link Control (HDLC) data channel on the controller.

Figure 3: Stack for T3 ATM Interfaces

Figure 4: Stack for T3 Frame and E3 Frame Interfaces

NOTE: For a detailed description of interface types and specifiers, see
Interface Types and Specifiers in JunosE Command Reference Guide. For
information about interfaces, see Planning Your Network in JunosE System
Basics Configuration Guide.
This section describes how to identify T3 and E3 interfaces.
A T3/E3 controller on an ATM or frame interface is identified using the slot/port format,
where:
slot—Number of the slot in which the line module resides in the chassis. In ERX7xx
models, line module slots are numbered 2-6 (slots 0 and 1 are reserved for SRP
modules). In ERX14xx models, line module slots are numbered 0–5 and 8–13 (slots 6
Chapter 2: Configuring T3 and E3 Interfaces
49