Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 153

path ds3 t1 framing
path ds3 t1 shutdown
path ds3 snmp trap link-status
Copyright © 2010, Juniper Networks, Inc.
Use to assign a text description or an alias to a T1 or fractional T1 channel on a T3 (DS3)
over channelized SONET/SDH interface.
You can use this command to help you identify the interface and keep track of interface
connections.
The description or alias can be a maximum of 80 characters.
Use "show controllers sonet ds3" on page 155 to display the text description.
Examples
host1(config-controller)#path 12 ds3 1 t1 28 description boston_t1_on_t3
host1(config-controller)#path 12 ds3 1 t1 28/5
description washington_fractional_t1_on_t3
Use the no version to remove the text description or alias.
See path ds3 t1 description.
Use to configure the T1 framing format for a T3 interface.
You must specify either esf (extended superframe) or sf (superframe) framing.
The framing format you choose must be compatible with the framing format at the
other end of the line.
Example
host1(config-controll)#path 12 ds3 1 t1 28 framing sf
Use the no version to restore the default value, esf framing.
See path ds3 t1 framing.
Use to disable T1 channels or a subchannel.
T1 channels and subchannels are enabled by default.
Examples
host1(config-controll)#path 12 ds3 t1 5,9,14-17 shutdown
host1(config-controll)#path 12 ds3 t1 28/5 shutdown
Use the no version to restart a disabled interface.
See path ds3 t1 shutdown.
Use to enable SNMP link status processing for T1 channels or a subchannel.
The default disables SNMP link status processing.
Examples
host1(config-controll)#path 2 ds3 3 t1 28 snmp trap link-status
host1(config-controll)#path 2 ds3 3 t1 28/5 snmp trap link-status
Chapter 4: Configuring Channelized OCx/STMx Interfaces
131