Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 227

show ip mac-validate interface
Copyright © 2010, Juniper Networks, Inc.
host1#show interfaces tenGigabitEthernet 4/0/0
TenGigabitEthernet4/0/0 is Up, Administrative status is Up
Hardware is Marvell GT64260, address is 0090.1a42.14b5
Primary MAU is 10000BASE-LR 10km, secondary MAU is XFP (Empty)
TX Output Power: 480.8 uW
MTU: Operational 1522, Administrative 1522
Duplex Mode: Operational Full Duplex, Administrative Full Duplex
Speed: Operational 10000 Mbps, Administrative 10000 Mbps
Debounce: State is Disabled
Link: Operational Primary Link Selected,
Administrative Link Selected Automatically
Link Failover Timeout: Operational 336 ms, Administrative default
Primary link selected 1 time, Secondary link selected 0 times
Primary link signal not detected, Secondary link signal not detected
Cleararp: State is Disabled
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 0, Unicast 0
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Out: Bytes 768, Unicast 0
Multicast 0, Broadcast 12
Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 0
Collisions: Single 0, Multiple 0, Late 0, Excessive 0
Policed Statistics:
In: 0, Out: 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
See show interfaces.
Use to display the status of the MAC address validation on the physical interface.
Field descriptions
FastEthernet interfaceSpecifier—On the ERX14xx models, ERX7xx models, and ERX310
router , the Fast Ethernet or Gigabit Ethernet interface slot/port; on the E120 and
E320 routers, the Gigabit Ethernet or 10-Gigabit Ethernet interface slot/adapter/port
Keyword assigned to interface—Options: Strict or Loose
Address—IP address of the entry
Hardware Addr—Physical (MAC) address of the entry
Example
host1:boston#show ip mac-validate interface fastEthernet 11/0
FastEthernet11/0: Strict
Address Hardware Addr
3.3.3.3 0090.1a30.3365
4.4.4.4 0090.1a30.3368
See show ip mac-validate interface.
Chapter 5: Configuring Ethernet Interfaces
RX Input Power: 1 uW
205