Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual page 216

JunosE 11.3.x Physical Layer Configuration Guide
interface tenGigabitEthernet
ip mac-validate
194
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
Use to select a 10-Gigabit Ethernet interface on the E120 or E320 router.
NOTE: On the ES2-S2 10GE PR IOA, you can configure only the primary
port, 0. The router automatically uses the redundant port, 0R, if the primary
port fails.
Use the slot/adapter/port format.
Example—Selects a 10-Gigabit Ethernet interface on the ES2-S1 10GE IOA
host1(config)#interface tenGigabitEthernet 4/0/0
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface tenGigabitEthernet.
Use to enable or disable MAC address validation on a per interface basis.
Use the strict keyword to prevent transmission of IP packets that do not reside in the
validation table.
Use the loose keyword to enable IP packets to pass through even though the packets
do not have entries in the validation table. Only packets that have matching IP–MAC
pair entries in the table are validated.
The default behavior is not to perform MAC address validation.
Example
host1(config)#interface gigabitEthernet 2/0
host1(config-if)#ip address 4.4.4.2 255.255.255.0
host1(config-if)#ip mac-validate strict
host1(config-if)#exit
Use the no version to disable the command.
NOTE: For additional information about MAC address validation, see the
arp validate command description in JunosE IP, IPv6, and IGP Configuration
Guide.
See ip mac-validate.
Copyright © 2010, Juniper Networks, Inc.