Monitoring And Maintaining Tunneling Status - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Monitoring and Maintaining Tunneling Status

Monitoring and Maintaining Tunneling Status
Table 13-2
Layer 2 protocol tunneling.
Table 13-2 Commands for Monitoring and Maintaining Tunneling
Command
clear l2protocol-tunnel counters
show dot1q-tunnel
show dot1q-tunnel interface interface-id
show l2protocol-tunnel
show errdisable recovery
show l2protocol-tunnel interface interface-id
show l2protocol-tunnel summary
show vlan dot1q tag native
For detailed information about these displays, see the command reference for this release.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
13-18
shows the privileged EXEC commands for monitoring and maintaining IEEE 802.1Q and
Purpose
Clear the protocol counters on Layer 2 protocol tunneling ports.
Display IEEE 802.1Q tunnel ports on the switch.
Verify if a specific interface is a tunnel port.
Display information about Layer 2 protocol tunneling ports.
Verify if the recovery timer from a Layer 2 protocol-tunnel error disable
state is enabled.
Display information about a specific Layer 2 protocol tunneling port.
Display only Layer 2 protocol summary information.
Display the status of native VLAN tagging on the switch.
Chapter 13 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
78-17058-01