Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 588

Chapter 30 Configuring QoS
Command
Step 6 police {rate-bps | cir cir-bps}
Step 7 conform-action [transmit]
Step 8
exceed-action [drop]
Step 9
exit
Step 10 class class-map-name
78-17058-01
Purpose
Define a policer for the priority class of traffic.
• For rate-bps, specify average traffic rate in bits per second
(bps). The range is 64000 to 1000000000.
Note When you use the police command with the priority
command in an output policy, the police rate range and the
cir range is 64000 to 1000000000 bps, even though the
range that appears in the CLI help is 8000 to 1000000000.
You cannot attach an output service policy with an
out-of-range rate.
For cir cir-bps, specify a committed information rate (CIR)
•
in bits per second (bps). The range is 64000 to 1000000000.
Although visible in the command-line help string, the
Note
burst-size option is not supported in output policy maps.
The switch does not allow you to attach an output service
policy map that has a configured burst size.
(Optional) Enter the action to be taken on packets that conform to
the CIR. If no action is entered, the default action is to send the
packet.
Note You can enter a single conform-action as part of the
command string following the police command. You can
also enter a carriage return after the police command and
enter policy-map class police configuration mode to enter
the conform-action. When the police command is
configured with priority in an output policy map, only the
default conform-action of transmit is supported.
Although visible in the command-line help string, the
other police conform actions are not supported in output
policy maps.
(Optional) Enter the action to be taken for packets that do not
conform to the CIR. If no action is entered, the default action is to
drop the packet.
Note You can enter a single exceed-action as part of the
command string following the police command. You can
also enter a carriage return after the police command and
enter policy-map class police configuration mode to enter
the exceed-action. When the police command is
configured with priority in an output policy map, only the
default exceed-action of drop is supported. Although
visible in the command-line help string, the other police
exceed actions are not supported in output policy maps.
Exit policy-map class configuration mode for the priority class.
Enter the name of the first nonpriority class, and enter policy-map
class configuration mode for that class.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring QoS
30-51