Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 223

Understanding VLANs
Figure 11-1
Figure 11-1
Cisco router
Gigabit
Ethernet
VLANs are often associated with IP subnetworks. For example, all the end stations in a particular IP
subnet belong to the same VLAN. Interface VLAN membership on the switch is assigned manually on
an interface-by-interface basis. When you assign switch interfaces to VLANs by using this method, it is
known as interface-based, or static, VLAN membership.
Note The switch does not support VLAN Trunking Protocol (VTP).
Traffic between VLANs must be routed. Switches that are running the metro IP access image can route
traffic between VLANs by using switch virtual interfaces (SVIs). To route traffic between VLANs, an
SVI must be explicitly configured and assigned an IP address. For more information, see the
Virtual Interfaces" section on page 9-5
This section includes these topics:
• Supported VLANs, page 11-3
• Normal-Range VLANs, page 11-3
• Extended-Range VLANs, page 11-4
VLAN Port Membership Modes, page 11-4
•
UNI VLANs, page 11-5
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
11-2
shows an example of VLANs segmented into logically defined networks.
VLANs as Logically Defined Networks
Engineering
VLAN
Marketing
VLAN
and the "Configuring Layer 3 Interfaces" section on page
Chapter 11 Configuring VLANs
Accounting
VLAN
Floor 3
Floor 2
Floor 1
"Switch
9-20.
78-17058-01