Changing The Igmp Query Timeout For Igmpv2; Changing The Maximum Query Response Time For Igmpv2 - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Chapter 34 Configuring IP Multicast Routing

Changing the IGMP Query Timeout for IGMPv2

If you are using IGMPv2, you can specify the period of time before the switch takes over as the querier
for the interface. By default, the switch waits twice the query interval controlled by the ip igmp
query-interval interface configuration command. After that time, if the switch has received no queries,
it becomes the querier.
You can configure the query interval by entering the show ip igmp interface interface-id privileged
EXEC command.
Beginning in privileged EXEC mode, follow these steps to change the IGMP query timeout. This
procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 no shutdown
Step 4
ip igmp querier-timeout seconds
Step 5
end
Step 6 show ip igmp interface [interface-id]
Step 7 copy running-config startup-config
To return to the default setting, use the no ip igmp querier-timeout interface configuration command.

Changing the Maximum Query Response Time for IGMPv2

If you are using IGMPv2, you can change the maximum query response time advertised in IGMP
queries. The maximum query response time enables the switch to quickly detect that there are no more
directly connected group members on a LAN. Decreasing the value enables the switch to prune groups
faster.
Beginning in privileged EXEC mode, follow these steps to change the maximum query response time.
This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
no shutdown
Step 4
ip igmp query-max-response-time
seconds
78-17058-01
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Enable the port, if necessary. By default, UNIs are disabled, and NNIs
are enabled.
Specify the IGMP query timeout.
The default is 60 seconds (twice the query interval). The range is 60
to 300.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Enable the port, if necessary. By default, UNIs are disabled, and NNIs
are enabled.
Change the maximum query response time advertised in IGMP queries.
The default is 10 seconds. The range is 1 to 25.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring Optional IGMP Features
34-29