Table of Contents
Advertisement
Chapter 9
Configuring Interface Characteristics
•
This example shows how to define an interface-range named enet_list to include ports 1 and 2 and to
verify the macro configuration:
Switch# configure terminal
Switch(config)# define interface-range enet_list gigabitethernet0/1 - 2
Switch(config)# end
Switch# show running-config | include define
define interface-range enet_list GigabitEthernet0/1 - 2
This example shows how to create a multiple-interface macro named macro1 and assign all of the
interfaces in the range to a VLAN:
Switch# configure terminal
Switch(config)# define interface-range macro1 fastethernet0/1 - 2, gigabitethernet0/1 - 2
Switch(config)# interface range macro macro1
Switch(config-if-range)# switchport access vlan 20
Switch(config-if-range)# no shut
Switch(config-if-range)# end
This example shows how to enter interface range configuration mode for the interface-range
macro enet_list:
Switch# configure terminal
Switch(config)# interface range macro enet_list
Switch(config-if-range)#
This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.
Switch# configure terminal
Switch(config)# no define interface-range enet_list
Switch(config)# end
Switch# show run | include define
Switch#
Configuring Ethernet Interfaces
These sections contain this configuration information:
•
•
•
•
•
•
78-17058-01
All interfaces defined as in a range must be the same type (all Fast Ethernet ports, all Gigabit
Ethernet ports, all EtherChannel ports, or all VLANs), but you can combine multiple interface types
in a macro.
Default Ethernet Interface Configuration, page 9-12
Configuring Interface Speed and Duplex Mode, page 9-14
Configuring IEEE 802.3x Flow Control, page 9-17
Configuring Auto-MDIX on an Interface, page 9-18
Adding a Description for an Interface, page 9-19
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring Ethernet Interfaces
9-11
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
