Clearing Configuration Information; Clearing The Startup Configuration File; Deleting A Stored Configuration File; Working With Software Images - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Working with Software Images

This example shows how to store a startup configuration file on a server:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin2
Switch(config)# end
Switch# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [switch2-confg]?
Write file switch2-confg on host 172.16.101.101?[confirm]
![OK]

Clearing Configuration Information

You can clear the configuration information from the startup configuration. If you reboot the switch with
no startup configuration, the switch enters the setup program so that you can reconfigure the switch with
all new settings.

Clearing the Startup Configuration File

To clear the contents of your startup configuration, use the erase nvram: or the erase startup-config
privileged EXEC command.
You cannot restore the startup configuration file after it has been deleted.
Caution

Deleting a Stored Configuration File

To delete a saved configuration from flash memory, use the delete flash:filename privileged EXEC
command. Depending on the setting of the file prompt global configuration command, you might be
prompted for confirmation before you delete a file. By default, the switch prompts for confirmation on
destructive file operations. For more information about the file prompt command, see the Cisco IOS
Command Reference for Release 12.2.
You cannot restore a file after it has been deleted.
Caution
Working with Software Images
This section describes how to archive (download and upload) software image files, which contain the
system software, the Cisco IOS code, and the embedded device manager software.
Instead of using the copy privileged EXEC command or the archive tar privileged EXEC command, we
Note
recommend using the archive download-sw and archive upload-sw privileged EXEC commands to
download and upload software image files.
You can download a switch image file from a TFTP, FTP, or RCP server to upgrade the switch software.
For information about upgrading your switch by using a TFTP server, see the release notes
You can replace the current image with the new one or keep the current image in flash memory after a
download.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
B-18
Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
78-17058-01