Monitoring And Maintaining The Interfaces - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Monitoring and Maintaining the Interfaces

Note If Layer 2 Gigabit Ethernet interfaces are configured to accept frames greater than the 10/100 interfaces,
jumbo frames received on a Layer 2 Gigabit Ethernet interface and sent on a Layer 2 10/100 interface
are dropped.
Beginning in privileged EXEC mode, follow these steps to change the MTU size for all 10/100 or Gigabit
Ethernet interfaces:
Command
Step 1 configure terminal
Step 2
system mtu bytes
Step 3
system mtu jumbo bytes
Step 4
end
Step 5
copy running-config startup-config
Step 6 reload
If you enter a value that is outside the allowed range for the specific type of interface, the value is not
accepted.
After the switch reloads, you can verify your settings by entering the show system mtu privileged EXEC
command.
This example shows how to set the maximum packet size for a Gigabit Ethernet port to 1800 bytes:
Switch(config)# system jumbo mtu 1800
Switch(config)# exit
Switch# reload
This example shows the response when you try to set Gigabit Ethernet interfaces to an out-of-range
number:
Switch(config)# system mtu jumbo 25000
% Invalid input detected at '^' marker.
Monitoring and Maintaining the Interfaces
These sections contain interface monitoring and maintenance information:
•
•
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
9-22
Monitoring Interface Status, page 9-23
Clearing and Resetting Interfaces and Counters, page 9-24
Shutting Down and Restarting the Interface, page 9-24
Chapter 9
Purpose
Enter global configuration mode.
(Optional) Change the MTU size for all interfaces on
the switch that are operating at 10 or 100 Mbps. The
range is 1500 to 1546 bytes; the default is 1500 bytes.
(Optional) Change the MTU size for all Gigabit
Ethernet interfaces on the switch. The range is 1500 to
9000 bytes; the default is 1500 bytes.
Return to privileged EXEC mode.
Save your entries in the configuration file.
Reload the operating system.
^
Configuring Interface Characteristics
78-17058-01