Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 830

Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Before you begin downloading or uploading an image file by using RCP, do these tasks:
•
•
•
•
For more information, see the documentation for your RCP server.
Downloading an Image File By Using RCP
You can download a new image file and replace or keep the current image.
Beginning in privileged EXEC mode, follow Steps 1 through 6 to download a new image from an RCP
server and overwrite the existing image. To keep the current image, go to Step 6.
Command
Step 1
Step 2
Step 3
configure terminal
Step 4 ip rcmd remote-username username
Step 5
end
78-17058-01
Ensure that the workstation acting as the RCP server supports the remote shell (rsh).
Ensure that the switch has a route to the RCP server. The switch and the server must be in the same
subnetwork if you do not have a router to route traffic between subnets. Check connectivity to the
RCP server by using the ping command.
If you are accessing the switch through the console or a Telnet session and you do not have a valid
username, make sure that the current RCP username is the one that you want to use for the RCP
download. You can enter the show users privileged EXEC command to view the valid username. If
you do not want to use this username, create a new RCP username by using the ip rcmd
remote-username username global configuration command to be used during all archive
operations. The new username is stored in NVRAM. If you are accessing the switch through a Telnet
session and you have a valid username, this username is used, and there is no need to set the RCP
username. Include the username in the archive download-sw or archive upload-sw privileged
EXEC command if you want to specify a username only for that operation.
When you upload an image to the RCP to the server, it must be properly configured to accept the
RCP write request from the user on the switch. For UNIX systems, you must add an entry to the
.rhosts file for the remote user on the RCP server. For example, suppose the switch contains these
configuration lines:
hostname Switch1
ip rcmd remote-username User0
If the switch IP address translates to Switch1.company.com, the .rhosts file for User0 on the RCP
server should contain this line:
Switch1.company.com Switch1
Purpose
Verify that the RCP server is properly configured by
referring to the "Preparing to Download or Upload an Image
File By Using RCP" section on page
Log into the switch through the console port or a Telnet
session.
Enter global configuration mode.
This step is required only if you override the default remote
username (see Steps 4 and 5).
(Optional) Specify the remote username.
Return to privileged EXEC mode.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Working with Software Images
B-28.
B-29