Checking And Saving The Running Configuration - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Checking and Saving the Running Configuration

Command
Step 5 ip default-gateway ip-address
Step 6 end
Step 7
show interfaces vlan vlan-id
Step 8
show ip redirects
Step 9 copy running-config startup-config
To remove the switch IP address, use the no ip address interface configuration command. If you are
removing the address through a Telnet session, your connection to the switch will be lost. To remove the
default gateway address, use the no ip default-gateway global configuration command.
For information on setting the switch system name, protecting access to privileged EXEC commands,
and setting time and calendar services, see
Checking and Saving the Running Configuration
You can check the configuration settings you entered or changes you made by entering this privileged
EXEC command:
Switch# show running-config
Building configuration...
Current configuration : 2010 bytes
!
version 12.2
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname 3400-3
!
enable password cisco
!
no aaa new-model
ip subnet-zero
no ip domain-lookup
!
table-map test
default copy
!
no file verify auto
!
spanning-tree mode rapid-pvst
spanning-tree extend system-id
!
vlan internal allocation policy ascending
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
3-10
Chapter 3
Purpose
Enter the IP address of the next-hop router interface that is directly
connected to the switch where a default gateway is being configured. The
default gateway receives IP packets with unresolved destination IP
addresses from the switch.
Once the default gateway is configured, the switch has connectivity to the
remote networks with which a host needs to communicate.
When your switch is configured to route with IP, it does not need
Note
to have a default gateway set.
Return to privileged EXEC mode.
Verify the configured IP address.
Verify the configured default gateway.
(Optional) Save your entries in the configuration file.
Chapter 5, "Administering the Switch."
Assigning the Switch IP Address and Default Gateway
78-17058-01