Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 200

Chapter 9 Configuring Interface Characteristics
Command
Step 6
show interfaces [interface-id]
Step 7 copy running-config startup-config
When using the interface range global configuration command, note these guidelines:
•
•
•
This example shows how to use the interface range global configuration command to set the speed on
ports 1 and 2 to 100 Mbps:
Switch# configure terminal
Switch(config)# interface range fastethernet0/1 - 2
Switch(config-if-range)# no shutdown
Switch(config-if-range)# speed 100
This example shows how to use a comma to add different interface type strings to the range to enable
Fast Ethernet ports 1 to 3 and Gigabit Ethernet ports 1 and 2 to receive IEEE 802.3x flow control pause
frames:
Switch# configure terminal
Switch(config)# interface range fastethernet0/1 - 3 , gigabitethernet0/1 - 2
Switch(config-if-range)# flowcontrol receive on
If you enter multiple configuration commands while you are in interface range mode, each command is
executed as it is entered. The commands are not batched together and executed after you exit interface
range mode. If you exit interface range configuration mode while the commands are being executed,
some commands might not be executed on all interfaces in the range. Wait until the command prompt
reappears before exiting interface range configuration mode.
78-17058-01
Valid entries for port-range:
– vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
– fastethernet module/{first port} - {last port}, where the module is always 0
– gigabitethernet module/{first port} - {last port}, where the module is always 0
port-channel port-channel-number - port-channel-number, where the port-channel-number
–
is 1 to 48
When you use the interface range command with port channels, the first and last port
Note
channel number must be active port channels.
The interface range command only works with VLAN interfaces that have been configured with
the interface vlan command. The show running-config privileged EXEC command displays the
configured VLAN interfaces. VLAN interfaces not displayed by the show running-config
command cannot be used with the interface range command.
All interfaces defined as in a range must be the same type (all Fast Ethernet ports, all Gigabit
Ethernet ports, all EtherChannel ports, or all VLANs), but you can enter multiple ranges in a
command.
Purpose
Verify the configuration of the interfaces in the range.
(Optional) Save your entries in the configuration file.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Using Interface Configuration Mode
9-9