Configuring An Originating Address Other Than The Rp Address - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Ethernet access switch
Hide thumbs Also See for ME 3400G-2CS - Ethernet Access Switch:
Table of Contents

Advertisement

Configuring MSDP
Command
Step 5
show running-config
Step 6
copy running-config startup-config
Note that the ip msdp originator-id global configuration command also identifies an interface to be
used as the RP address. If both the ip msdp border sa-address and the ip msdp originator-id global
configuration commands are configured, the address derived from the ip msdp originator-id command
specifies the RP address.
To return to the default setting (active sources in the dense-mode region do not participate in MSDP),
use the no ip msdp border sa-address interface-id global configuration command.

Configuring an Originating Address other than the RP Address

You can allow an MSDP speaker that originates an SA message to use the IP address of the interface as
the RP address in the SA message by changing the Originator ID. You might change the Originator ID
in one of these cases:
Beginning in privileged EXEC mode, follow these steps to allow an MSDP speaker that originates an
SA message to use the IP address on the interface as the RP address in the SA message. This procedure
is optional.
Command
Step 1
configure terminal
Step 2
ip msdp originator-id interface-id
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
If both the ip msdp border sa-address and the ip msdp originator-id global configuration commands
are configured, the address derived from the ip msdp originator-id command specifies the address of
the RP.
To prevent the RP address from being derived in this way, use the no ip msdp originator-id interface-id
global configuration command.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
35-18
If you configure a logical RP on multiple switches in an MSDP mesh group.
If you have a switch that borders a PIM sparse-mode domain and a dense-mode domain. If a switch
borders a dense-mode domain for a site, and sparse-mode is being used externally, you might want
dense-mode sources to be known to the outside world. Because this switch is not an RP, it would not
have an RP address to use in an SA message. Therefore, this command provides the RP address by
specifying the address of the interface.
Purpose
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Configures the RP address in SA messages to be the address of the
originating device interface.
For interface-id, specify the interface on the local switch.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 35
Configuring MSDP
78-17058-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents