Ip Source Guard Configuration Guidelines; Enabling Ip Source Guard - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Chapter 18 Configuring DHCP Features and IP Source Guard

IP Source Guard Configuration Guidelines

Note IP source guard is supported only when the metro access or metro IP access image is running on the
switch.
These are the configuration guides for IP source guard:
•
•
•
•
•
•
•
•

Enabling IP Source Guard

Beginning in privileged EXEC mode, follow these steps to enable and configure IP source guard on an
interface.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3 no shutdown
Step 4 ip verify source
or
ip verify source port-security
78-17058-01
You can configure static IP bindings only on nonrouted ports. If you enter the ip source binding
mac-address vlan vlan-id ip-address interface interface-id global configuration command on a
routed interface, this error message appears:
Static IP source binding can only be configured on switch port.
When IP source guard with source IP filtering is enabled on a VLAN, DHCP snooping must be
enabled on the access VLAN to which the interface belongs.
If you are enabling IP source guard on a trunk interface with multiple VLANs and DHCP snooping
is enabled on all the VLANs, the source IP address filter is applied on all the VLANs.
Note If IP source guard is enabled and you enable or disable DHCP snooping on a VLAN on the
trunk interface, the switch might not properly filter traffic.
When IP source guard with source IP and MAC address filtering is enabled, DHCP snooping and
port security must be enabled on the interface.
When configuring IP source guard on interfaces on which a private VLAN is configured, port
security is not supported.
IP source guard is not supported on EtherChannels.
You can enable this feature when IEEE 802.1x port-based authentication is enabled.
If the number of ternary content addressable memory (TCAM) entries exceeds the maximum
available, the CPU usage increases.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Enable the port, if necessary. By default, UNIs are disabled and NNIs are
enabled.
Enable IP source guard with source IP address filtering.
Enable IP source guard with source IP and MAC address filtering.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring IP Source Guard
18-15