Removing Dynamic Address Entries; Configuring Mac Address Notification Traps - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Managing the MAC Address Table
Beginning in privileged EXEC mode, follow these steps to configure the dynamic address table aging
time:
Command
Step 1 configure terminal
Step 2
mac address-table aging-time [0 |
10-1000000] [vlan vlan-id]
Step 3
end
Step 4
show mac address-table aging-time
Step 5 copy running-config startup-config
To return to the default value, use the no mac address-table aging-time global configuration command.

Removing Dynamic Address Entries

To remove all dynamic entries, use the clear mac address-table dynamic command in privileged EXEC
mode. You can also remove a specific MAC address (clear mac address-table dynamic address
mac-address), remove all addresses on the specified physical port or port channel (clear mac
address-table dynamic interface interface-id), or remove all addresses on a specified VLAN (clear
mac address-table dynamic vlan vlan-id).
To verify that dynamic entries have been removed, use the show mac address-table dynamic privileged
EXEC command.

Configuring MAC Address Notification Traps

MAC address notification enables you to track users on a network by storing the MAC address activity
on the switch. Whenever the switch learns or removes a MAC address, an SNMP notification can be
generated and sent to the NMS. If you have many users coming and going from the network, you can set
a trap interval time to bundle the notification traps and reduce network traffic. The MAC notification
history table stores the MAC address activity for each hardware port for which the trap is enabled. MAC
address notifications are generated for dynamic and secure MAC addresses; events are not generated for
self addresses, multicast addresses, or other static addresses.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
5-22
Purpose
Enter global configuration mode.
Set the length of time that a dynamic entry remains in the MAC
address table after the entry is used or updated.
The range is 10 to 1000000 seconds. The default is 300. You can also
enter 0, which disables aging. Static address entries are never aged
or removed from the table.
For vlan-id, valid IDs are 1 to 4094. Do not enter leading zeros.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 5 Administering the Switch
78-17058-01