Configuring Snmp; Default Snmp Configuration; Snmp Configuration Guidelines - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Configuring SNMP

Configuring SNMP
These sections contain this configuration information:
•
•
•
•
•
•
•
•
•

Default SNMP Configuration

Table 27-4
Table 27-4
Feature
SNMP agent
SNMP trap receiver
SNMP traps
SNMP version
SNMPv3 authentication
SNMP notification type
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration

SNMP Configuration Guidelines

If the switch starts and the witch startup configuration has at least one snmp-server global configuration
command, the SNMP agent is enabled.
An SNMP group is a table that maps SNMP users to SNMP views. An SNMP user is a member of an
SNMP group. An SNMP host is the recipient of an SNMP trap operation. An SNMP engine ID is a name
for the local or remote SNMP engine.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
27-6
Default SNMP Configuration, page 27-6
SNMP Configuration Guidelines, page 27-6
Disabling the SNMP Agent, page 27-7
Configuring Community Strings, page 27-8
Configuring SNMP Groups and Users, page 27-9
Configuring SNMP Notifications, page 27-11
Setting the Agent Contact and Location Information, page 27-14
Limiting TFTP Servers Used Through SNMP, page 27-15
SNMP Examples, page 27-15
shows the default SNMP configuration.
Default SNMP Configuration
commands.
Default Setting
1
Disabled .
None configured.
None enabled except the trap for TCP connections (tty).
If no version keyword is present, the default is Version 1.
If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
If no type is specified, all notifications are sent.
Chapter 27 Configuring SNMP
78-17058-01