Troubleshooting Dynamic-Access Port Vlan Membership; Vmps Configuration Example - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Configuring VMPS
•
This is an example of output for the show vmps privileged EXEC command:
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 3
VMPS domain server: 172.20.128.86 (primary, current)
Reconfirmation status
---------------------
VMPS Action:

Troubleshooting Dynamic-Access Port VLAN Membership

The VMPS shuts down a dynamic-access port under these conditions:
•
•
To disable and re-enable a disabled dynamic-access port, enter the shutdown interface configuration
command followed by the no shutdown interface configuration command.

VMPS Configuration Example

Figure 11-5
dynamic-access ports. In this example, these assumptions apply:
•
•
•
•
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
11-28
VMPS Action—the result of the most recent reconfirmation attempt. A reconfirmation attempt can
occur automatically when the reconfirmation interval expired, or you can force it by entering the
vmps reconfirm privileged EXEC command.
1
172.20.128.87
other
The VMPS is in secure mode, and it does not allow the host to connect to the port. The VMPS shuts
down the port to prevent the host from connecting to the network.
More than 20 active hosts reside on a dynamic-access port.
shows a network with a VMPS server switch and VMPS client switches with
The VMPS server and the VMPS client are separate switches.
The Catalyst 6500 series Switch A is the primary VMPS server.
The Catalyst 6500 series Switch C and Switch J are secondary VMPS servers.
End stations are connected to the clients, Switch B and Switch I.
The database configuration file is stored on the TFTP server with the IP address 172.20.22.7.
Chapter 11 Configuring VLANs
78-17058-01