Manual Installation - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

5.3.1 Manual Installation

1 Make sure the device meets the necessary requirements (see
in the
2 On the target device, open a Web browser to the following address:
https://server/zenworks-setup
where server is the DNS name or IP address of a ZENworks Server.
The Web browser displays a list of deployment packages for the Adaptive Agent. For each
architecture (32-bit and 64-bit), there are two types of packages:
Network: The network package downloads and installs only the preagent to the target device;
the preagent then downloads and installs the ZENworks Adaptive Agent from the ZENworks
Server.
Standalone: The standalone package downloads the preagent and Adaptive Agent to the target
device; the preagent then installs the Adaptive Agent from the local device. The standalone
package is useful when you need to install the ZENworks Adaptive Agent to a device that is
currently disconnected from the network. You can save the package to removable media (CD,
USB flash drive, and so forth) and have the standalone device run the package from the media.
The Adaptive Agent is installed to the device, but no registration or management occurs until
the device connects to the network.
3 Click the name of the deployment package you want to use; save the package to the device's
local drive or run it from the ZENworks Server.
4 If you downloaded the package, launch the package on the device.
For information about options you can use with the package when launching it from a
command line, see
Management Discovery, Deployment, and Retirement
5 Upon completion of the installation, a message is displayed asking whether to reboot. Select
one of the following options:
Do nothing and auto-reboot occurs after 5 minutes.
Click Cancel. You will need to reboot later.
Click OK to reboot immediately.
When the device reboots, it is registered in the Management Zone and the ZENworks icon is
placed in the notification area (system tray).
82 ZENworks 10 Configuration Management Administration Quick Start
ZENworks 10 Configuration Management Installation
"Manually Deploying the
"Managed Device
Guide).
Agent" in the ZENworks 10 Configuration
Reference.
Requirements"